PROPER OPERATION & SECURING OF THE SCORPION MODEL 'HR' NON-ELECTRIC INITIATOR
ATTENTION: The HR Model Non-Electric Initiator is designed for use with the Remington #209, Federal, or CCI shotgun shell primer. Any HR unit used with a primer other than those mentioned herein will void our ninety (90) day limited warranty.
1. Pull back and align Cock Pin (F) so that is seats in the locked position
as shown above
2. Remove Safety Pin from Through Hole (B) in Flash Guard (C).
3. Slide Flash Guard (C) toward Cock Pin (F) so as to expose the Nozzle (A).
4. While twisting clockwise pull Nozzle (A) away from fork (not shown).
5. Place shotgun shell primer in base of Nozzle (A).
6. Replace Nozzle (A) onto forks until snug and seated properly.
7. Slide Flash Guard (C) forward toward Nozzle (A).
8. Place Safety Pin into Safety Pin Hole (E).
9. String Non-Electric firing line through Through Hole (B) and up and around into Nozzle
(A).
10. When blast site is secured and free of people remove Safety Pin from Safety Pin Hole
(E).
11. Apply backward pressure to Cock Pin (F) and while holding it stationary rotate it into
Firing Pin Track (D).
12. Release pressure on Cock Pin (F) so as to let it freely move along Firing Pin Track
(D).
1. Remove spent Non-Electric line from Nozzle (A) and Through Holes (B).
2. Repeat step [1] under "TO INITIATE" so as to re-cock the Cock Pin (F).
3. Slide Flash Guard (C) down toward Cock Pin (F).
4. While twisting clockwise pull Nozzle (A) away from Forks (not shown).
5. Remove spent shotgun shell primer from base of Nozzle(A).
6. Clean as necessary and replace Nozzle(A) to Forks until snug and seated properly.
7. Slide Flash Guard(C) forward toward Nozzle (A).
8. Rotate Cock Pin (F) into Firing Pin Track (D) and gently guide forward until it stops.
9. Place Safety Pin into Through Holes (B).